You know that boiler and heat exchanger expanders are properly and meticulously built heat exchanger tube expander tools to meet the highest standards of quality and precision. With the appropriate level of care, you will get consistent quality results from these valuable pipe expanders if you are using these spending tools or will start using them. You should know how to maintain it to get the best results. Once you know how to care for and keep them, you can gain perfect results.

Cleanliness Is Essential:

Make sure that you thoroughly remove all rust and dirt from your tools from time to time. Additionally, cleaning all types of scale and other foreign substances from the inside and outside of each pipe will help avoid harm to the tool. Thrust bearing grease must be checked before each use for consistent performance results.

You Should Set The Collar Opening:

You know how you can change the throat depth to accommodate the pipe protruding from or even flush with the pipe plate. You can start by loosening the forward cap screw using a hex wrench that is there. Then, turn the collar clockwise or counterclockwise to include up to 1/16″ of clearance. Then re-tighten the overall retaining screw. The point is that when you do such things from time to time, you can be sure that the mechanism is working properly with the tools.

Make Sure There Is Proper Lubrication:

Friction and metal forming create a lot of heat during the pipe expansion period. Reducing the heat will reduce the chance of damage. A good pressure-resistant lubricant may be the perfect way to reduce heat. After you turn each pipe, make sure you clean and cool the expander in a solvent or light oil. The expansion was then properly lubricated again. The point is that lubrication can guarantee that your tools will last for a long time and remain undamaged. You will definitely find a greater smoothness in the pipe extension with this method.

Tool Rotation:

It is a good practice to keep two identical amplifiers when you have more than fifteen tubes to roll. This is what helps cool one amplifier while the other one is used for the next ten to fifteen pipes.

Start Rolling:

Did you know that the condenser expander for the tube should be kept inside the tube so that the neck pushes against the tube plate? The roll must always be 1/16″ inside the back of the tube sheet. Avoid rolling outside the tube sheet. Now that you have rolled it correctly, you will see that the extension tube works flawlessly. Remember that for larger diameter boiler expansion tubes, keep the expander in the tube so that the flare only rolls about 1/2 inch away from the open end of the tube before starting to roll.

Conclusion:

In summary, when you spend money on a boiler tube expander tool, make sure you take good care of these machines to keep them in top working condition. So this will help you for the long life of the tube expander for your pipes.